#CHANGE THE MAC ADDRESS OF MY ROUTER HOW TO#
#CHANGE THE MAC ADDRESS OF MY ROUTER PASSWORD#

#CHANGE THE MAC ADDRESS OF MY ROUTER HOW TO#

Luckily, this is not an overly difficult task and certainly not as frustrating as, say, learning how to disable IPV6 on a router. If the Internet Port IP AddressВ is showing as 0.0.0.0, please see How to powercycle your home networkВ to refresh your network and you should be able to receive an IP address from your ISP.When you revert your router to its default settings, the MAC address will also reset to the original setting. ДЇor older routers with the Smart Wizard UI, you will be able to see Router Status under Maintenance on the left blue panel. To check the Internet IP address, click ADVANCED >Administration>Router Status.Note: If you have an older NETGEAR router with the Smart Wizard UI (as shown in the screenshot below), click Basic Settings under Setup on the left blue panel. For most cable Internet connections, follow the settings shown below then click the Apply button. If you still cannot access the router, please see How do I log in to my NETGEAR home router?.Otherwise, a factory reset is needed to restore the router to factory defaults.В To perform a factory reset, see Restoring a NETGEAR home router to the factory default settings Please try other passwords that you might have changed to.

#CHANGE THE MAC ADDRESS OF MY ROUTER PASSWORD#

If the default username and password is not working, you might have changed the password.

The username and passwordВ are case-sensitive.

The default username is admin and the default password is password.

You are prompted to log into the router.Open a webВ browser and type the router's IP address which would be either or in the address bar and press Enter.

Make sure that the ports where the two Ethernet cables are connectedВ are lit.

Connect the Cable modem to the Internet/WAN port of the router and the computer to any of the available LAN ports at the back of the router.

If you are unsure which computer was used, contact your ISP, and ask what MAC address was registered.

It may be on a sticker on some part of the computer,В or you canВ follow the steps in this article to find your MAC address: How to find a computer's MAC address.

It is a 12-character hexadecimal number, so it may contain the characters 0-9 and A-F (example: 00:21:CC:69:F0:F1).

If you cannot do this, you will have to find the computers MAC address so that you can enter it into the router manually: Note: Make sure thatВ you are usingВ the computer that works with your Internet connectionВ and disconnect all other computers from the router.

After setting up a newВ NETGEAR router youВ have Internet connectivity onВ one computer, but your additional computers are not able to connect.

This article will help you configure MAC Spoofing on your NETGEAR router to bypass the 'locking' your ISP has configured on your connection. This is called 'spoofing the MAC address. To fix this, you will need to configure the router to pretend to have the sameВ MAC address as the ISP 'approved' computer, instead of its own. MAC addresses areВ a unique number or identifierВ built into modems, routers and other network hardware. Some Internet Service Providers (ISPs) allow only a certain number of computers to connect to the Internet by default.В They do this by 'locking' the connection to the unique Media Access Control (MAC) address of your computer.

Change the mac address of my router